Software & Hardware to do multi color printing with Sharpies
active 2023-08-25 → 2026-02-08 (UTC)
Activity over time
Daily event counts in the loaded window
Line chart, 899 days from 2023-08-25 to 2026-02-08. Pushes: 0 total, peak 0 in a day. Pull requests: 0 total, peak 0 in a day. Issues: 4 total, peak 3 in a day. Comments: 8 total, peak 3 in a day. Stars: 69 total, peak 3 in a day.
- Pushes
- Pull requests
- Issues
- Comments
- Stars
Stars, PRs, issues and forks are under-captured in the later part of this window. GH Archive progressively stopped capturing non-push events during 2026 — −95% or worse by the end of the window. Every series here except Pushes fades for that reason, so a decline above reflects the archive, not this repository. Pushes stay reliable throughout, so read them, and the contributor counts derived from them, as the real signal. Data health has the measurements.
Top contributors
Pushes, PRs, issues, reviews and comments — stars and forks excluded, so this is contribution rather than popularity
| Contributor | Contributions | Pushes | PRs | Comments |
|---|---|---|---|---|
| doggohusk | 8 | 0 | 0 | 5 |
| thisnyjared | 3 | 0 | 0 | 3 |
| tmnaturalequilibrium-design | 1 | 0 | 0 | 0 |
Recent activity
Latest issues, pull requests and releases
- Issue#125tmnaturalequilibrium-design2026-02-08 19:23PORTING for BambuStudio-PrusaSlicer-OrcaSlicer
- Issue comment#121thisnyjared2024-01-10 23:26Missing certain settings that should be enabled by default in the cura profile in software folder
- Issue comment#92thisnyjared2024-01-08 00:22Suggestion: have a double sided holder for 12 markers
- Issue comment#120thisnyjared2024-01-07 23:53Suggestion: Compatibility with newer models in ender 3 line up
- Issue comment#9doggohusk2023-09-03 02:11PrusaSlicer support?
- Issue comment#113doggohusk2023-08-28 22:54add support for Crayola markers
- Issue comment#120doggohusk2023-08-28 22:50Suggestion: Compatibility with newer models in ender 3 line up
- Issue#121doggohusk2023-08-28 22:42Missing certain settings that should be enabled by default in the cura profile in software folder
- Issue#120doggohusk2023-08-28 01:56[Suggestion] Compatibility with newer models in ender 3 line up
- Issue comment#114doggohusk2023-08-28 01:45Calibration for Ender 3 V2 Neo
- Issue#119doggohusk2023-08-28 01:41X Y Pen offset constantly changes by .5 MM after each print
- Issue comment#9doggohusk2023-08-25 01:08PrusaSlicer support?
Totals cover only the window loaded into ClickHouse and count events, not GitHub's lifetime totals — 69 stars here means stars gained during the window, not the repo's star count.